Fan Jets

Posted by On December 11, 2014 0 Comment

A clear, widespread, fan –shaped display. Ideal installation at an angle of 45* & used as peripheral effect in a location zero wind. Most effective used in multiples. Optional Swivel Joints.
This nozzle generates a narrow film of water that widens out over its parabolic trajectory due to the exit angle. It is commonly used in Out door water fountains in groups and Swimming pool in combination with other man features.
Fan jets is categorized under the truly impressive and charming water shapes. Its nothing alike 3.00 to 6.00 mm thick water film pattern catches every body’s attention in all kinds of application.
Fan jets water effect is displayed best in lower height and at angles between 35 to 90 degrees of horizontal axis. For uniform illumination lit with LED Lights and places to closer to the jets pointing at the middle of the stream.

1-1-2


JK-600 Series Fan Jets ( water level Independent )
Reference JK-601 JK-602 JK-603 JK-604 JK-605 JK-606
Connection 1″ 1″ 1″ 1″ 1 ½ “ 2″
Orifice 3mm 3mm 4mm 4mm 5mm 4@4mm
Material of Construction Cast Bronze/ Brass Cast Bronze/ Brass Cast Bronze/ Brass Cast Bronze/ Brass Stainless Steel Stainless Steel
Appro. Weight, Kg. – – – – – –

JK-600 Series Performance of jets
Spray
Length
( m )
 Spray
Height
( m )
 Spray
Height
( m )
 Q L/Min Q L/Min Q L/Min Q L/Min Q L/Min Q L/Min
0.50 0.20 0.20 40 40 53 53 105 140
1.00 0.35 0.35 65 65 85 85 125 210
1.50 0.45 0.50 81 81 105 105 180 275
2.00 0.60 0.70 90 90 120 120 250 310
2.50 0.85 0.85 110 110 145 145 280 –
3.00 1.00 1.00 124 124 165 165 310 –

INFORMATION AT GLANCE

JK-600 Series –Fan Jets ( water level Independent )
  • For best performance in the lower , solid water skin spray effect , feed jets with non turbulent water.
  • Truly impressive water shape
  • Highly visible and wind resistant.
  • Perfect for side water features.
  • Not water level dependent..
  • Proper suction strainer must use at pump .
  • 100 % filter water is recommended where feasible.
  • Easy to clean.

IMPORTANT NOTE:

  • Dimensions & Material of Construction Subject to change without Notice.
  • Stated flows and head pressure requirement for any listed spray height are required at the nozzle. Designer & engineer shall be responsible for the accuracy of system flow rates & system head loss requirement.