Air bubbler Nozzle

Air Bubbler Jets/ Foam Jets Give White Mound of Aerated water at low height, Foam Jet becomes a splashy, frothy column at high Height & provide highly visible fluffy white spray effects. This Nozzles Produce a White Water Cone this particular beautiful when lit up at night. Combining effect of suctioning air and drawing water from the pond, thus producing Bubbles of water that’s look like floating beads when lit at night.1-1-2




JK-200 Series Air Bubbler Jets / Foam Jets (Water Level Dependent )

Reference JK-201 JK-202 JK-203 JK-204 JK-205 JK-206
Connection ½” BSP 1” BSP 1½” BSP 2” BSP 2 ½” BSP 3” BSP
Orifice 19mm 40mm 50mm 75mm 82mm 87mm
Material of Construction Cast Bronze/ Brass Cast Bronze/ Brass Cast Bronze/ Brass Cast Bronze/ Brass Cast Bronze/ Brass Cast Bronze/ Brass
Appro, weight(Kg)

JK-200 Series Performance of jets

Jets Height in Mts Q L/Min Q L/Min Q L/Min Q L/Min Q L/Min Q L/Min
0.50 27.00 70.00 135.00 215.00
1.00 36.00 85.00 170.00 265.00 315.00 370.00
1.50 46.00 95.00 208.00 310.00 370.00 430.00
2.00 115.00 230.00 340.00 410.00 480.00
2.50 127.00 260.00 365.00 440.00 510.00
3.00 135.00 285.00 390.00 465.00 540.00
4.00 339.00 435.00 550.00 650.00
5.00 380.00 480.00 625.00 770.00
6.00 520.00 690.00 860.00
8.00 1020.00 1050.00 1100.00
10.00 1105.00 1160.00
1290.00

INFORMATION:

JK-200 Series Air Bubbler Jets / Foam Jets

  • Must be installed on a Determinate height due to its water level dependency.
  • It will increase stream height if decrease it when water level rise.
  • constant unvarying water level is required.
  • It required non- turbulent water supply.
  • 100% filter water is recommended.

IMPORTANT NOTE:

  • Dimensions & Material of Construction Subject to change without Notice.
  • Stated flows and head pressure requirement for any listed spray height are required at the nozzle. Designer & engineer shall be responsible for the accuracy of system flow rates & system head loss requirement.